Rohde & Schwarz RTP Series - Page 1783

Remote control commands
R&S
®
RTP
1783User Manual 1337.9952.02 ─ 12
BUS<m>:TBTO:MODE <Mode>
Selects the direction of the full-duplex signal you want to look at.
Suffix:
<m>
.
1..4
Parameters:
<Mode> MASTer | SLAVe | AUTO
*RST: AUTO
BUS<m>:TBTO:POLarity <Polarity>
Selects the polarity of the data signal.
Suffix:
<m>
.
1..4
Parameters:
<Polarity> NORMal | INVert
*RST: NORMal
BUS<m>:TBTO:SYMRate <SymbolRate>
Defines the rate of ternary symbols.
Suffix:
<m>
.
1..4
Parameters:
<SymbolRate> Range: 10 to 1500
Increment: 1E-3
*RST: 750
Default unit: MSymb/s
22.17.12.2 Decode results
To show the results on the screen, use the following commands:
●
BUS<m>:RESult on page 1549
BUS<m>:TBTO:RESult:FCOunt?...................................................................................1784
BUS<m>:TBTO:RESult:FRAMe<n>:BITRate?.................................................................1784
BUS<m>:TBTO:RESult:FRAMe<n>:CRC?..................................................................... 1784
BUS<m>:TBTO:RESult:FRAMe<n>:DATA?.................................................................... 1785
BUS<m>:TBTO:RESult:FRAMe<n>:DESTaddress?.........................................................1785
BUS<m>:TBTO:RESult:FRAMe<n>:DSYMbol?...............................................................1785
BUS<m>:TBTO:RESult:FRAMe<n>:FTYPe?.................................................................. 1786
BUS<m>:TBTO:RESult:FRAMe<n>:NUMWords?............................................................1786
BUS<m>:TBTO:RESult:FRAMe<n>:SRCaddress?.......................................................... 1786
BUS<m>:TBTO:RESult:FRAMe<n>:SSYMbol?...............................................................1787
BUS<m>:TBTO:RESult:FRAMe<n>:STARt?................................................................... 1787
Protocols