Rohde & Schwarz RTP Series - Page 183

Acquisition and waveform setup
R&S
®
RTP
183User Manual 1337.9952.02 ─ 12
Figure 5-13: Probe setup for R&S RT-ZD01
Specific settings for predefined probes are the following:
Predefined probe.........................................................................................................183
Offset to mean.............................................................................................................184
Line impedance...........................................................................................................184
Predefined probe
List of probes that are known to the instrument. The instrument lists only probes that
match the instrument coupling and, if connected, also the used adapter.
Select the used probe on the list. The corresponding "Vertical unit" and the "Attenua-
tion" or "Gain" are shown.
All other unrecognized probes that are not listed, are unknown probes. For these
probes, set "Predefined probe" to "None". See Chapter 5.6.8, "Setup for unknown
probes", on page 187.
Remote command:
PROBe<m>:SETup:ATTenuation:DEFProbe on page 1224
Probes