Rohde & Schwarz RTP Series - Page 1869

Remote control commands
R&S
®
RTP
1869User Manual 1337.9952.02 ─ 12
SEARch:TRIGger:DPHY:WCOunt:MIN <SearchName>,<HSWordCountMin>
SEARch:TRIGger:DPHY:WCOunt:MIN? <SearchName>
Specifies a word bit pattern, or sets the the start value of a pattern range.
Parameters:
<HSWordCountMin> Numeric or string pattern, see Chapter 22.4.6, "Bit pattern
parameter", on page 1148. The string parameter accepts the bit
value X (don't care).
Parameters for setting and query:
<SearchName>
22.17.14.5
D-PHY search results
In all SEARch:RESult:DPHY:FRAMe<m> commands, the suffix <m> selects the frame
number in the list of search results.
SEARch:RESult:DPHY:FCOunt?................................................................................... 1869
SEARch:RESult:DPHY:FRAMe<m>:CS?........................................................................1869
SEARch:RESult:DPHY:FRAMe<m>:DATA?.................................................................... 1870
SEARch:RESult:DPHY:FRAMe<m>:DTName?............................................................... 1870
SEARch:RESult:DPHY:FRAMe<m>:DTYPe?..................................................................1870
SEARch:RESult:DPHY:FRAMe<m>:ECC?..................................................................... 1871
SEARch:RESult:DPHY:FRAMe<m>:PACKet<n>:IDX?..................................................... 1871
SEARch:RESult:DPHY:FRAMe<m>:PACKet<n>:VALue?................................................. 1871
SEARch:RESult:DPHY:FRAMe<m>:STARt?...................................................................1872
SEARch:RESult:DPHY:FRAMe<m>:STATe?...................................................................1872
SEARch:RESult:DPHY:FRAMe<m>:STOP?................................................................... 1872
SEARch:RESult:DPHY:FRAMe<m>:TYPE?....................................................................1873
SEARch:RESult:DPHY:FRAMe<m>:VCHannel?............................................................. 1873
SEARch:RESult:DPHY:FCOunt? <SearchName>
Returns the number of frames within the search result for the selected serial bus.
Query parameters:
<SearchName>
Return values:
<FrameCount> Range: 0 to 100000
Increment: 1
*RST: 0
Usage: Query only
SEARch:RESult:DPHY:FRAMe<m>:CS? <SearchName>
Returns the checksum for the selected frame within the search result.
Suffix:
<m>
.
*
Protocols