Rohde & Schwarz RTP Series - Page 1953

Remote control commands
R&S
®
RTP
1953User Manual 1337.9952.02 ─ 12
Setting parameters:
<Frame>
<Field>
<Operator> ANY | OFF | EQUal | NEQual | LTHan | LETHan | GTHan |
GETHan | INRange | RANGe
ANY = OFF
The index of the required pattern is not relevant.
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
This condition requires one endpoint value to be set using
TRIGger<m>:CMSB:ADVanced:IMIN.
INRange | RANGe
This condition requires a range of endpoint values to be set
using TRIGger<m>:CMSB:ADVanced:IMAX and
TRIGger<m>:CMSB:ADVanced:IMIN.
Usage:
Setting only
22.17.16.3 Filter
BUS<m>:CMSB:FILTer:ENABle <Enable>
Enables filtering for the custom serial bus.
Suffix:
<m>
.
1..4
Parameters:
<Enable> ON | OFF
*RST: OFF
BUS<m>:CMSB:FILTer:ERENable <ErrorName>, <Enabler>
Enables filtering on error.
Suffix:
<m>
.
1..4
Setting parameters:
<ErrorName>
<Enabler> ON | OFF
Usage: Setting only
BUS<m>:CMSB:FILTer:ERRor<n>:ENABle <Enable>
Enables filtering on error. You can filter all error types in parallel.
Suffix:
<m>
.
1..4
Protocols