Rohde & Schwarz RTP Series - Page 1964

Remote control commands
R&S
®
RTP
1964User Manual 1337.9952.02 ─ 12
SEARch:TRIGger:CMSB:ERENable <SearchName>,<ErrorName>, <Enabler>
SEARch:TRIGger:CMSB:ERRor<m>:ENABle <SearchName>,<Enable>
SEARch:TRIGger:CMSB:ERRor<m>:ENABle? <SearchName>
Defines the error type to be searched for. You can search for all error types in parallel.
Suffix:
<m>
.
*
Parameters:
<Enable> ON | OFF
*RST: ON
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:CMSB:FIENable <SearchName>,<Frame>, <Field>, <Enabler>
Enables or disables the specific field within the defined frame to be searched for.
Setting parameters:
<SearchName>
<Frame>
<Field>
<Enabler> ON | OFF
Usage: Setting only
SEARch:TRIGger:CMSB:FRENable <SearchName>,<Frame>, <Enabler>
Enables or disables the specific frame to be searched for.
Setting parameters:
<SearchName>
<Frame>
<Enabler> ON | OFF
Usage: Setting only
SEARch:TRIGger:CMSB:BIT <SearchName>,<Frame>, <Field>, <Bit>
SEARch:TRIGger:CMSB:FRAMe<m>:FLD<n>:BIT <SearchName>,<BitState>
SEARch:TRIGger:CMSB:FRAMe<m>:FLD<n>:BIT? <SearchName>
Sets the bit state of a field to be searched that only consists of one bit.
Suffix:
<m>
.
*
Protocols