Rohde & Schwarz RTP Series - Page 1979

Remote control commands
R&S
®
RTP
1979User Manual 1337.9952.02 ─ 12
Usage: Event
Asynchronous command
BUS<m>:EBTB:FAUToscale
Starts software algorithms for determining the signal threshold levels and bitrate.
Suffix:
<m>
.
1..4
Usage: Event
Asynchronous command
22.17.17.2
Trigger settings
The trigger suffix <m> is always 1 and can be omitted. It selects the trigger event: Only
the A-trigger is available for triggering on serial buses.
To trigger on a serial bus, make sure that:
●
TRIGger<m>:SOURce[:SELect] is set to SBUS.
●
The sources of the serial bus are channel signals: use BUS<m>:...:SOURce
commands.
●
Decoding is enabled: BUS<m>[:STATe] is set to ON.
TRIGger<m>:EBTB:DISParityerr................................................................................... 1979
TRIGger<m>:EBTB:DX.................................................................................................1979
TRIGger<m>:EBTB:DY.................................................................................................1980
TRIGger<m>:EBTB:EBPA.............................................................................................1980
TRIGger<m>:EBTB:GLITcherror....................................................................................1980
TRIGger<m>:EBTB:SSTYpe......................................................................................... 1980
TRIGger<m>:EBTB:SYME............................................................................................1980
TRIGger<m>:EBTB:SYMType....................................................................................... 1981
TRIGger<m>:EBTB:TBPA.............................................................................................1981
TRIGger<m>:EBTB:STYPe...........................................................................................1981
TRIGger<m>:EBTB:UNK.............................................................................................. 1981
TRIGger<m>:EBTB:DISParityerr <DispError>
Defines, if a trigger on a disparity error is activated or not.
Parameters:
<DispError> ON | OFF
*RST: OFF
TRIGger<m>:EBTB:DX <DXSymbol>
Sets thex value of the data character Dx.y to be triggered on, if TRIGger<m>:EBTB:
SYMType is set to Dxy.
Protocols