Rohde & Schwarz RTP Series - Page 1981

Remote control commands
R&S
®
RTP
1981User Manual 1337.9952.02 ─ 12
TRIGger<m>:EBTB:SYMType <SymbolType>
Selects the data character (Dx.y) or control character to bea triggered on. You can
specify he value of the data character to be triggered on with TRIGger<m>:EBTB:DX
and TRIGger<m>:EBTB:DY.
Parameters:
<SymbolType> DXY | K280 | K281 | K282 | K283 | K284 | K285 | K286 | K287 |
K237 | K277 | K297 | K307
*RST: K285
TRIGger<m>:EBTB:TBPA
<TBPattern>
Sets the 10-bit pattern to be triggered on, if TRIGger<m>:EBTB:STYPe is set to TB.
Parameters:
<TBPattern>
TRIGger<m>:EBTB:STYPe <Type>
Selects the type of condition to be triggered on for 8b10b.
Parameters:
<Type> KD | EB | TB | EXPRession | ERRor
KD: K/D symbol
EB: 8-bit pattern
TB: 10-bit pattern
*RST: KD
TRIGger<m>:EBTB:UNK <UnkError>
Defines, if a trigger on a unknown symbol error is activated or not.
Parameters:
<UnkError> ON | OFF
*RST: OFF
22.17.17.3 Decode results
In all BUS<m>:EBTB:SYMBol<n> commands, the suffix <m> selects the serial bus and
the suffix <n> selects the symbol in the decode table.
BUS<m>:EBTB:SYMBol<n>:DATA?...............................................................................1982
BUS<m>:EBTB:SYMBol<n>:STARt?..............................................................................1982
BUS<m>:EBTB:SYMBol<n>:STATus?............................................................................1982
BUS<m>:EBTB:SYMBol<n>:STOP?..............................................................................1983
BUS<m>:EBTB:SYMBol<n>:BYTE?.............................................................................. 1983
BUS<m>:EBTB:SYMBol<n>:KDCode?...........................................................................1983
BUS<m>:EBTB:SYMBol<n>:TENBit?.............................................................................1984
Protocols