Rohde & Schwarz RTP Series - Page 2089

Remote control commands
R&S
®
RTP
2089User Manual 1337.9952.02 ─ 12
<n> *
Specifies the field number within the frame.
<o> *
Parameters:
<IndexMax> Specifies the end value for the index range within the field.
The index range, increment and *RST values depend on the
field type.
TRIGger<m>:USBPd:IMIN <Frame>, <Field>, <Data>
TRIGger<m>:USBPd:FRAMe<n>:FLD<o>:IMIN <IndexMin>
Specifies the index, or sets the start value of an index range.
Suffix:
<m>
.
1..3
<n> *
Specifies the field number within the frame.
<o> *
Parameters:
<IndexMin> Specifies the index value or index start value within the field.
The index range, increment and *RST values depend on the
field type.
TRIGger<m>:USBPd:IOPerator <Frame>, <Field>, <Operator>
TRIGger<m>:USBPd:FRAMe<n>:FLD<o>:IOPerator <IndexOperator>
TRIGger<m>:USBPd:FRAMe<n>:FLD<o>:BIT <BitState>
Sets the bit state for the field.
Suffix:
<m>
.
1..3
<n> *
<o> *
Parameters:
<BitState> ONE | ZERO | DC
*RST: DC
22.17.21.3 Decode results
In all BUS<m>:USBPd:RESult:FRAMe<n> commands, the suffix <m> selects the
serial bus and the suffix <n> selects the frame number in the decode table.
BUS<m>:USBPd:RESult:FCOunt?.................................................................................2090
BUS<m>:USBPd:RESult:FRAMe<n>:DATA?.................................................................. 2090
BUS<m>:USBPd:RESult:FRAMe<n>:FLD<o>:FVAL?......................................................2090
BUS<m>:USBPd:RESult:FRAMe<n>:FLD<o>:STATus?...................................................2091
Protocols