Rohde & Schwarz RTP Series - Page 2125

Remote control commands
R&S
®
RTP
2125User Manual 1337.9952.02 ─ 12
Parameters:
<SourceL0> C1W1 | C2W1 | C3W1 | C4W1 | M1 | M2 | M3 | M4 | M5 | M6 |
M7 | M8 | R1 | R2 | R3 | R4
*RST: C1W1
BUS<m>:PCIE:LONE:SOURce <SourceL1>
BUS<m>:PCIE:LTWO:SOURce <SourceL2>
BUS<m>:PCIE:LTHRee:SOURce <SourceL3>
Sets the signal sources for the corresponding logical lane.
Suffix:
<m>
.
1..4
Parameters:
<SourceL3> C1W1 | C2W1 | C3W1 | C4W1 | M1 | M2 | M3 | M4 | M5 | M6 |
M7 | M8 | R1 | R2 | R3 | R4 | NONE
*RST: LONe: C2W1, LTWo: C3W1, LTHree: C4W1
BUS<m>:PCIE:LZER:THRHigh <ThresholdL0High>
BUS<m>:PCIE:LONE:THRHigh <ThresholdL1High>
BUS<m>:PCIE:LTWO:THRHigh <ThresholdL2High>
BUS<m>:PCIE:LTHRee:THRHigh <ThresholdL3High>
Sets the high threshold value for the respective lane.
Suffix:
<m>
.
1..4
Parameters:
<ThresholdL3High> Range: -5 to 5
Increment: 1E-3
*RST: 0.02
Default unit: V
BUS<m>:PCIE:LZER:THRLow <ThresholdL0Low>
BUS<m>:PCIE:LONE:THRLow <ThresholdL1Low>
BUS<m>:PCIE:LTWO:THRLow <ThresholdL2Low>
BUS<m>:PCIE:LTHRee:THRLow <ThresholdL3Low>
BUS<m>:PCIE:SMLanes <Active>
Enables the display of the result in multiple lanes.
Suffix:
<m>
.
1..4
Parameters:
<Active> ON | OFF
*RST: ON
Protocols