Rohde & Schwarz RTP Series - Page 2199

Remote control commands
R&S
®
RTP
2199User Manual 1337.9952.02 ─ 12
The setting affects only the settings of the first MSO bus (Bus1). You can set the hyste-
resis for all buses with BUS<m>:PARallel:HYSTeresis<n>.
See also: DIGital<m>:THCoupling
Suffix:
<m>
.
0..15
Number of the digital channel
Channel groups: 0..3; 4..7; 8..11; 12..15
Parameters:
<Hysteresis> MAXIMUM | MAXimum | ROBUST | ROBust | NORMAL |
NORMal
MAXIMUM = MAXimum
Maximum value that is possible and useful for the signal and its
settings
ROBUST = ROBust
Different hysteresis values for falling and rising edges to avoid
an undefined state of the trigger system.
NORMAL = NORMal
The instrument sets a value suitable for the signal and its set-
tings.
DIGital<m>:LABel <Label>
Sets a name for the indicated digital channel. The name is displayed in the diagram.
The setting affects only the settings of the first MSO bus (Bus1). You can set the label
for all buses with BUS<m>:PARallel:BIT<n>:LABel.
Suffix:
<m>
.
0..15
Number of the digital channel
Parameters:
<Label> String containing the channel name
DIGital<m>:DESKew <Deskew>
Sets an individual delay for each digital channel to time-align it with other digital chan-
nels. The deskew value compensates delays that are known from the circuit specifics
or caused by the different length of cables.
The setting affects only the settings of the first MSO bus (Bus1). You can set the
deskew for all buses with BUS<m>:PARallel:BIT<n>:DESKew.
Suffix:
<m>
.
0..15
Number of the digital channel
Mixed signal option (MSO, R&S RTP-B1)