Rohde & Schwarz RTP Series - Page 2205

Remote control commands
R&S
®
RTP
2205User Manual 1337.9952.02 ─ 12
BUS<m>:PARallel:DISPlay:SHBU <ShowBus>
Shows or hides the indicated parallel bus. If enabled, the resulting bus signal and bus
values are displayed in the diagram.
Suffix:
<m>
.
1..4
Selects the parallel bus.
Parameters:
<ShowBus> ON | OFF
*RST: OFF
BUS<m>:PARallel:DISPlay:BTYP <BusRepres>
Selects the display type of the indicated parallel bus.
Suffix:
<m>
.
1..4
Selects the parallel bus.
Parameters:
<BusRepres> COMB | ANALog
COMB
Displays the decoded bus signal with bus values.
ANALog
Displays the bus value as amplitude, similar to an analog wave-
form.
*RST: COMB
BUS<m>:PARallel:CLON <Clocked>
Defines if the bus is a clocked bus - one of the digital channels serves as clock of the
bus.
Suffix:
<m>
.
1 | 2
Selects the parallel bus. The clocked bus is available on parallel
buses 1 and 2.
Parameters:
<Clocked> ON | OFF
*RST: OFF
BUS<m>:PARallel:CLOCk <ClockSource>
Selects the digital channel used as clock of the indicated parallel bus.
Mixed signal option (MSO, R&S
RTP-B1)