Rohde & Schwarz RTP Series - Page 2236

Remote control commands
R&S
®
RTP
2236User Manual 1337.9952.02 ─ 12
WGENerator<m>:VOLTage:HIGH <High>
Sets the high signal level of the output waveform.
Suffix:
<m>
.
1..2
Parameters:
<High> Range: -5.99 to 6
Increment: 0.1
*RST: 0.5
Default unit: V
WGENerator<m>:VOLTage:INVersion
<Inversion>
Enables inversion, which swaps the two poles of the waveform.
Suffix:
<m>
.
1..2
Parameters:
<Inversion> ON | OFF
*RST: OFF
WGENerator<m>:VOLTage:LOW <Low>
Sets the low signal level of the output waveform.
Suffix:
<m>
.
1..2
Parameters:
<Low> Range: -6 to 5.99
Increment: 0.1
*RST: -0.5
Default unit: V
WGENerator<m>:VOLTage:OFFSet <Offset>
Sets a voltage offset.
Suffix:
<m>
.
1..2
Parameters:
<Offset> Range: -5.995 to 5.995
Increment: 0.1
*RST: 0
Default unit: V
Waveform generator (option R&S RTP-B6)