Remote control commands
R&S
®
RTP
2276User Manual 1337.9952.02 ─ 12
Suffix:
<m>
.
1..2
Usage: Event
Asynchronous command
ADVJitter<m>:DCOMposition:CLENoisecomp
Clears all selected noise components.
Suffix:
<m>
.
1..2
Usage: Event
Asynchronous command
ADVJitter<m>:DCOMposition:SELNoisecomp
Selects all noise components.
Suffix:
<m>
.
1..2
Usage: Event
Asynchronous command
ADVJitter<m>:RESult:TRANsitions <TransitionType>
Sets the measurements for which transitions are displayed in the diagram.
Suffix:
<m>
.
1..2
Parameters:
<TransitionType> RISing | FALLing | BOTH
*RST: BOTH
ADVJitter<m>:RESult:LEVels <LevelType>
Sets which levels are considered for the display of the diagrams, rising, falling or both.
This setting is mostly relevant for histograms.
Suffix:
<m>
.
1..2
Parameters:
<LevelType> HIGH | LOW | BOTH
*RST: BOTH
Jitter analysis and clock data recovery
To Next Page
Loading...
