Rohde & Schwarz RTP Series - Page 2299

Remote control commands
R&S
®
RTP
2299User Manual 1337.9952.02 ─ 12
Suffix:
<m>
.
1..4
Selects the channel that is configured for deembedding.
<n> 1, only for available DUT
Parameters:
<Value> OFF | ON
Usage: Asynchronous command
DEEMbedding<m>:COMPonent<n>:LOAD:IMPedance? <Value>
Shows the source impedance of the DUT. If an R&S RT-ZM probe is connected, the
value depends on the selected probe mode: common mode, differential, or single-
ended measurement.
Suffix:
<m>
.
1..4
Selects the channel that is configured for deembedding.
<n> 1, only for available DUT
Return values:
<Value> Numeric value
Usage: Query only
Asynchronous command
22.23.3.3 R&S RT-ZM probe settings
This chapter lists the commands that correspond to the "Deembedding" > "RT-ZMxx"
dialog box. More commands are provided in Chapter 22.8.7.6, "Modular probes, deem-
bedding", on page 1221.
PROBe<m>:DEEMbedding:TIPModule[:SELect]............................................................. 2299
PROBe<m>:DEEMbedding:TIPModule:ZMA<n>:SUBModule...........................................2300
PROBe<m>:DEEMbedding:BANDwidth..........................................................................2300
PROBe<m>:DEEMbedding:TIPModule[:SELect] <ProbeTip>
Selects the tip module that is used for measurement.
Suffix:
<m>
.
1..4
Selects the channel to which the probe is connected.
Parameters:
<ProbeTip> NONE | ZMA10 | ZMA12 | ZMA14 | ZMA15 | ZMA30 | ZMA40 |
ZMA50 | CUST
*RST: ZMA10
Usage: Asynchronous command
Deembedding (Option R&S RTP-K121/-K122)