Rohde & Schwarz RTP Series - Status:operation Register; Status:questionable Registers

Remote control commands
R&S
®
RTP
2306User Manual 1337.9952.02 ─ 12
22.25.1 STATus:OPERation register
STATus:OPERation commands provide information on the activity of the instrument.
See also: "STATus:OPERation register" on page 1110
STATus:OPERation:CONDition?....................................................................................2306
STATus:OPERation[:EVENt]?........................................................................................2306
STATus:OPERation:ENABle..........................................................................................2306
STATus:OPERation:CONDition?
STATus:OPERation[:EVENt]?
The CONDition command returns information on actions the instrument is currently
executing. The contents of the register is retained.
The EVENt command returns information on actions the instrument has executed
since the last reading. Reading the EVENt register deletes its contents.
Bits:
●
0 = ALIGnment
●
2 = AUToset
●
3= WTRIgger (wait for trigger)
●
4= MEASuring
Usage:
Query only
STATus:OPERation:ENABle <Enable>
Controls the ENABle part of the STATus:OPERation register. The ENABle defines
which events in the EVENt part of the status register are forwarded to the OPERation
summary bit (bit 7) of the status byte. The status byte can be used to create a service
request.
Parameters:
<Enable> Range: 1 to 65535
Increment: 1
Example:
STATus:OPERation:ENABle 5
The ALIGnment event (bit 0) and AUToset event (bit 2) are for-
warded to the OPERation summary bit of the status byte.
22.25.2 STATus:QUEStionable registers
The commands of the STATus:QUEStionable subsystem control the status reporting
structures of the STATus:QUEStionable registers.
See also: "STATus:QUEStionable register" on page 1111
Status reporting