Rohde & Schwarz RTP Series - Page 277

Waveform analysis
R&S
®
RTP
277User Manual 1337.9952.02 ─ 12
X range ← Position/Range
Defines the width of the zoom area.
Remote command:
LAYout:ZOOM:HORZ:ABSolute:SPAN on page 1321
LAYout:ZOOM:HORZ:RELative:SPAN on page 1322
SEARch:RESDiagram:HORZ:ABSolute:SPAN on page 1512
SEARch:RESDiagram:HORZ:RELative:SPAN on page 1512
Y position ← Position/Range
Defines the y-value of the centerpoint of the zoom area.
Remote command:
LAYout:ZOOM:VERTical:ABSolute:POSition on page 1324
LAYout:ZOOM:VERTical:RELative:POSition on page 1325
SEARch:RESDiagram:VERT:ABSolute:POSition on page 1513
SEARch:RESDiagram:VERT:RELative:POSition on page 1514
Y range ← Position/Range
Defines the height of the zoom area.
Remote command:
LAYout:ZOOM:VERTical:RELative:SPAN on page 1325
LAYout:ZOOM:VERTical:ABSolute:SPAN on page 1324
SEARch:RESDiagram:VERT:ABSolute:SPAN on page 1513
SEARch:RESDiagram:VERT:RELative:SPAN on page 1514
X mode
Defines whether absolute or relative values are used to specify the x-axis values.
Remote command:
LAYout:ZOOM:HORZ:MODE on page 1320
SEARch:RESDiagram:HORZ:MODE on page 1512
Y mode
Defines whether absolute or relative values are used to specify the y-axis values.
Remote command:
LAYout:ZOOM:VERTical:MODE on page 1323
SEARch:RESDiagram:VERT:MODE on page 1514
Position coupling
Enables or disables the position coupling of coupled zooms. If position coupling is
enabled and you move one zoom area, the other coupled zoom areas are moved, too,
and keep their distance.
Remote command:
LAYout:ZOOM:POSCoupling on page 1320
Full height
Uses the full diagram height for the zoom area. Only horizontal zoom settings can be
changed.
Zoom