Measurements
R&S
®
RTP
363User Manual 1337.9952.02 ─ 12
Type
Selects the type of arithmetic measurement:
"Measure-
ment"
Performs an arithmetic operation between two measurement results.
You can select from the measurements enabled for "Amp/Time" or
"Spectrum".
Figure 8-8: Arithmetic with two measurement results
"Constant"
Performs an operation between a measurement result and a user
defined fixed Constant.
Figure 8-9: Arithmetic with a measurement result and a constant
Remote command:
MEASurement<m>:AMPTime:ARIThmetic:PARameter<n>:TYPE on page 1384
Automatic measurements
To Next Page
Loading...
