Measurements
R&S
®
RTP
364User Manual 1337.9952.02 ─ 12
Operand 1
Selects the first operand for the arithmetics. You can select one of the measurements,
that is enabled for the current measurement group.
Remote command:
MEASurement<m>:SPECtrum:ARIThmetic:PARameter<n>:AMPTime
on page 1387
MEASurement<m>:AMPTime:ARIThmetic:PARameter<n>:AMPTime on page 1383
MEASurement<m>:AMPTime:ARIThmetic:PARameter<n>:SPECtrum
on page 1384
MEASurement<m>:SPECtrum:ARIThmetic:PARameter<n>:SPECtrum
on page 1388
Operand 2 meas group / Operand 2
Selects the measurement group and the measurement result for the second operand.
You can select one of the measurements, that is enabled for the selected measure-
ment group.
Remote command:
MEASurement<m>:AMPTime:ARIThmetic:PARameter<n>:GROup on page 1383
MEASurement<m>:SPECtrum:ARIThmetic:PARameter<n>:GROup on page 1387
Operator
Selects the operation type to be performed on the selected operands. You can choose
between +, -, * and /.
"+"
Adds up the operands.
"-"
Subtracts "Operand 2"/"Constant" from "Operand 1".
"*"
Multiplies the operands.
"/"
Divides "Operand 1" by "Operand 2"/"Constant".
Remote command:
MEASurement<m>:AMPTime:ARIThmetic:OPERator on page 1382
Custom
Enable "Use" to apply the user-defined value for the "Unit".
Remote command:
MEASurement<m>:AMPTime:ARIThmetic:CUNState on page 1381
MEASurement<m>:SPECtrum:ARIThmetic:CUNState on page 1385
Constant
Sets a constant numeric value for the arithmetic operation, for the "Constant" measure-
ment type.
Remote command:
MEASurement<m>:AMPTime:ARIThmetic:CONStant on page 1380
MEASurement<m>:SPECtrum:ARIThmetic:CONStant on page 1384
Constant unit
Selects the unit for the Arithmetic for amplitude/time and spectrum measurements.
Automatic measurements
To Next Page
Loading...
