Rohde & Schwarz RTP Series - Page 397

Measurements
R&S
®
RTP
397User Manual 1337.9952.02 ─ 12
● Not at all.
As a result of the limit check, the specified actions are performed and an icon indi-
cates the status in the result box.
8.2.12.2 Limit and margin settings
Access: [Meas] > "Advanced" tab
If a check is selected, tap "Setup" to set the limit and margin values and the range of
valid measurement results
Type
Selects and enables the limit or margin check.
"Off"
No limit check is performed.
"Limit only"
Limits are checked for violation.
"Margin &
Limit"
Margins and limits are checked for violation.
Upper limit, Lower limit, Upper margin, Lower margin, Valid range
Set the limits and margins for each measurement, and also specify the valid range.
Automatic measurements