Rohde & Schwarz RTP Series - Page 475

Data and file management
R&S
®
RTP
475User Manual 1337.9952.02 ─ 12
the instrument settings, make sure to create a reference waveform from the channel
waveform before you save the One File.
The waveform generator/pattern generator and the pulse source state is saved as
"Off".
12.1.2.1 Save One File settings
Access: "Menu" key > "Save/Recall" key > "Save" tab > "One File"
Save to file
Enter the file name to save the One File data to, and select the file format with the for-
mat button on the right. Double-tap the file name to open the file selection dialog box.
See also: Chapter 12.5, "File selection dialog", on page 509.
By default, one file names have the prefix "OneFile_".
"Save"
Saves the data to the selected file.
"Save As..."
Opens the file selection dialog box and saves the data to the selected
file.
".zip"
Shows the file format.
Remote command:
SAVeset:ONEFile:NAME on page 1525
SAVeset:ONEFile:SAVE on page 1525
12.1.2.2 Load One File settings
Access: "Menu" key > "Save/Recall" key > "Recall" tab > "One File"
Save and recall user settings