Protocol analysis
R&S
®
RTP
589User Manual 1337.9952.02 ─ 12
"Identifier"
Sets the trigger to one specific identifier or an identifier range. Enter
only the 6-bit identifier without parity bits, not the protected identifier.
Description of trigger type specific settings: "Identifier setup: Condi-
tion, Frame ID min, Frame ID max" on page 590.
"Identifier OR"
Sets the trigger to a combination of up to four identifiers.
Description of trigger type specific settings: "Identifier OR setup: Mon-
itor, Frame ID" on page 591
LIN (option R&S RTP-K3)
To Next Page
Loading...
