Rohde & Schwarz RTP Series - Page 626

Protocol analysis
R&S
®
RTP
626User Manual 1337.9952.02 ─ 12
The SDI / SSM setup settings are the same as in the ARINC trigger setup, see "SDI /
SSM" on page 621.
Remote command:
SEARch:TRIGger:ARINc:SDI on page 1722
SEARch:TRIGger:ARINc:SSM on page 1723
Error Condition
Selects the error type to be searched for. You can select one or more error types as
search condition.
The error types are the same as in the ARINC trigger setup, see "Error Conditions"
on page 621
Remote command:
SEARch:TRIGger:ARINc:ERRor:CODing on page 1723
SEARch:TRIGger:ARINc:ERRor:PARity on page 1723
SEARch:TRIGger:ARINc:ERRor:TIMing on page 1723
13.8.6.2 ARINC search results
To get search results, "Enable" the search. You can minimize, shift or close the search
dialog.
The search results are listed in the search result table and marked in the waveform by
blue lines.
For an introduction to search results, see:
●
Chapter 11.1.2, "Search results", on page 449
●
Chapter 11.4.2, "Display zoom settings", on page 468
Remote commands:
●
SEARch:RESult:ARINc:WCOunt? on page 1725
●
SEARch:RESult:ARINc:WORD<m>:DATA? on page 1725
●
SEARch:RESult:ARINc:WORD<m>:LABel? on page 1724
●
SEARch:RESult:ARINc:WORD<m>:PATTern? on page 1724
●
SEARch:RESult:ARINc:WORD<m>:SDI? on page 1726
●
SEARch:RESult:ARINc:WORD<m>:SSM? on page 1725
●
SEARch:RESult:ARINc:WORD<m>:STARt? on page 1726
●
SEARch:RESult:ARINc:WORD<m>:STATe? on page 1726
●
SEARch:RESult:ARINc:WORD<m>:STOP? on page 1726
●
SEARch:RESult:ARINc:WORD<m>:SYMBol? on page 1725
ARINC 429 (option R&S
RTP-K7)