Rohde & Schwarz RTP Series - Page 644

Protocol analysis
R&S
®
RTP
644User Manual 1337.9952.02 ─ 12
See also: Chapter 13.1.1, "Setup - general settings", on page 512
Forward
Defines the forward signal settings.
You can choose between a differential and single-ended signal and set the forward
source channel for the waveform. Only analog channels are available for selection.
Remote command:
BUS<m>:HBTO:FTYP on page 1752
BUS<m>:HBTO:FDIF on page 1752
BUS<m>:HBTO:FDAP on page 1751
BUS<m>:HBTO:FDAM on page 1751
Reverse
Defines the reversed signal settings. The reverse direction is optional and can be dis-
abled.
You can choose between a differential and single-ended signal and set the reverse
source channel for the waveform. Only analog channels are available for selection.
Remote command:
BUS<m>:HBTO:RTYP on page 1753
BUS<m>:HBTO:RDIF on page 1753
BUS<m>:HBTO:RDAP on page 1752
BUS<m>:HBTO:RDAM on page 1752
Ethernet 100BASE-T1 (option R&S
RTP-57)