Rohde & Schwarz RTP Series - Page 677

Protocol analysis
R&S
®
RTP
677User Manual 1337.9952.02 ─ 12
13.11.5.2 1000BASE-T1 search results
To get search results, "Enable" the search. You can minimize, shift or close the search
dialog.
The search results are listed in the search result table and marked in the waveform by
blue lines.
For an introduction to search results, see:
●
Chapter 11.1.2, "Search results", on page 449
●
Chapter 11.4.2, "Display zoom settings", on page 468
Remote commands:
●
SEARch:RESult:TBTO:FCOunt? on page 1806
●
SEARch:RESult:TBTO:FRAMe<m>:TYPE? on page 1810
●
SEARch:RESult:TBTO:FRAMe<m>:STATe? on page 1809
●
SEARch:RESult:TBTO:FRAMe<m>:STARt? on page 1809
●
SEARch:RESult:TBTO:FRAMe<m>:STOP? on page 1809
●
SEARch:RESult:TBTO:FRAMe<m>:DESTaddress? on page 1806
●
SEARch:RESult:TBTO:FRAMe<m>:SRCaddress? on page 1808
●
SEARch:RESult:TBTO:FRAMe<m>:DATA? on page 1806
●
SEARch:RESult:TBTO:FRAMe<m>:CRC? on page 1806
●
SEARch:RESult:TBTO:FRAMe<m>:NUMWords? on page 1808
●
SEARch:RESult:TBTO:FRAMe<m>:FTYPe? on page 1807
●
SEARch:RESult:TBTO:FRAMe<m>:DSYMbol? on page 1807
●
SEARch:RESult:TBTO:FRAMe<m>:SSYMbol? on page 1808
●
SEARch:RESult:TBTO:FRAMe<m>:WORD<n>:TYPE? on page 1810
●
SEARch:RESult:TBTO:FRAMe<m>:WORD<n>:VALue? on page 1810
●
SEARch:RESult:TBTO:FRAMe<m>:WORD<n>:VSTR? on page 1811
13.11.5.3 Searching 1000BASE-T1 data
Prerequisite: A serial bus is configured for the 1000BASE-T1 signal to be decoded and
analyzed.
The search for events is set up in the following way:
1. Press the [Protocol] key and selet the "Shortcuts" tab.
2. Tap "Setup search".
3. If the dialog box does not contain a search entry, tap the "Add" icon to create one,
as described in "To create a user-defined search" on page 463.
4. Tap "Source" and select the serial bus that is set to 1000BASE-T1 (e.g. "SB1",
unless already selected).
The search dialog for 1000BASE-T1 protocol analysis opens.
Ethernet 1000BASE-T1 (option R&S
RTP-K58)