Rohde & Schwarz RTP Series - RFFE Decode Results; RFFE Label List

Protocol analysis
R&S
®
RTP
692User Manual 1337.9952.02 ─ 12
13.12.4 RFFE label list
Label lists are protocol-specific. A label list file for RFFE contains slave addresses
and/or register addresses and their symbolic names:
●
"SA": slave address (SID in the labal list file)
●
Address: register address.
●
"Symbolic label": symbolic name as combination of the slave name (SID text) and
the address name (Address text), specifying the device function
Example: RFFE label list file
# Labels for RFFE protocol
# Column order: SID, SID text, Address, Address text
# ---------------------------------------------------------------------------
@PROTOCOL_NAME = rffe
0x01,LM8335
0x01,LM8335,0x00,CMTL_REG
0x01,LM8335,0x01,GPO_PULL_DIR
0x01,LM8335,0x02,GPO_PULL_ENABLE
0x01,LM8335,0x03,GPO_OUT_HIGH_CFG
0x01,LM8335,0x04,GPO_OUT_MASK
0x01,LM8335,0x05,GPO_OUT_DATA
0x01,LM8335,0x1C,PM_TRIG
0x01,LM8335,0x1D,PROD_ID
0x01,LM8335,0x1E,MAN_ID
0x01,LM8335,0x1F,USID_REG
0x05,LM3279
0x05,LM3279,0x00,VSET_CTRL
0x05,LM3279,0x01,STATE_CTRL
0x05,LM3279,0x02,GPO_CTRL
0x05,LM3279,0x1C,PM_TRIG
0x05,LM3279,0x1D,PROD_ID
0x05,LM3279,0x1E,MAN_ID
0x05,LM3279,0x1F,USID_REG
0x0A,Test
See also: Chapter 13.1.4, "Content and format of the PTT file", on page 515.
Remote command:
●
BUS<m>:RFFE:SEQuence<n>:SYMBol? on page 1829
13.12.5 RFFE decode results
When the configuration of the serial bus is complete, the signal can be decoded:
1. In the "Protocol" dialog > "Setup" tab, enable "Decode".
2. In the "Protocol" dialog > "Display" tab, select additional result display settings:
"Show decode table" and "Show binary signals".
RFFE (option R&S
RTP-K40)