Protocol analysis
R&S
®
RTP
696User Manual 1337.9952.02 ─ 12
"Master Read"
Searches for Master Read command sequences. Additional search
parameters:
●
Address of the non-BOM master, see "Slave Addr." on page 696.
●
Register address, see "Address" on page 697.
●
Data pattern that is returned by the non-BOM master, see "Data"
on page 697.
"Master Write"
Searches for Master Write command sequences. Additional search
parameters:
●
Address of the non-BOM master, see "Slave Addr." on page 696
●
Register address, see "Address" on page 697
●
Data pattern to be written into the non-BOM, see "Data"
on page 697.
"Master Ownership Handover"
Searches for Master Ownership Handover command sequences.
Additional search parameters:
●
Address of the BOM-to-be, see "Slave Addr." on page 696
●
Data pattern of the confirmation sequence of the new BOM, see
"Data" on page 697.
"Interrupt Summary and Notification"
Searches for interrupts. Additional search parameters:
●
Slave address, see "Slave Addr." on page 696
●
Byte count, see "Byte count" on page 696
●
Data of the interrupt identification sequence, see
"Error Condition"
Searches for the selected errors, see "Error conditions"
on page 697.
Remote command:
SEARch:TRIGger:RFFE:TYPE on page 1833
Slave Addr.
Searches for a slave address or a slave address range.
In command sequences transferred between masters, this is the non-BOM address.
The slave address settings are the same as in the RFFE trigger setup, see "Slave
Addr. /MID " on page 689.
Remote command:
SEARch:TRIGger:RFFE:SADD:CONDition on page 1835
SEARch:TRIGger:RFFE:SADD:MIN on page 1836
SEARch:TRIGger:RFFE:SADD:MAX on page 1836
Byte count
Searches for a byte count or a byte count range.
The byte count settings are the same as in the RFFE trigger setup, see "Byte count"
on page 690
RFFE (option R&S
RTP-K40)
To Next Page
Loading...
