Rohde & Schwarz RTP Series - Page 697

Protocol analysis
R&S
®
RTP
697User Manual 1337.9952.02 ─ 12
Remote command:
SEARch:TRIGger:RFFE:BCOunt:CONDition on page 1835
SEARch:TRIGger:RFFE:BCOunt:MIN on page 1836
SEARch:TRIGger:RFFE:BCOunt:MAX on page 1836
Address
Searches for a register address or an address range.
The register address settings are the same as in the RFFE trigger setup, see
"Address" on page 689.
Remote command:
SEARch:TRIGger:RFFE:ADDRess:CONDition on page 1835
SEARch:TRIGger:RFFE:ADDRess:MIN on page 1836
SEARch:TRIGger:RFFE:ADDRess:MAX on page 1836
Data
Searches for a data pattern or a data word range. The setting is available for all
"Extended Register" command sequences, which can transfer more than one data
frame.
The data settings are the same as in the RFFE trigger setup, see "Data" on page 690.
Remote command:
SEARch:TRIGger:RFFE:DATA:DCON on page 1835
SEARch:TRIGger:RFFE:DATA:DMIN on page 1836
SEARch:TRIGger:RFFE:DATA:DMAX on page 1836
Index
Defines which data frames are relevant for the search. The setting is available for all
Extended Register command sequences, which can transfer more than one data
frame. To search for any data byte that fulfills the data pattern settings, set the index to
XX.
Remote command:
SEARch:TRIGger:RFFE:DATA:ICONdition on page 1835
SEARch:TRIGger:RFFE:DATA:IMIN on page 1836
SEARch:TRIGger:RFFE:DATA:IMAX on page 1836
Data
Defines the pattern of the interrupt identification sequence, which consists of interrupt
slots 15 to 0. The setting is only available for "Interrupt Summary and Notification"
command sequence.
Remote command:
SEARch:TRIGger:RFFE:INTerrupt on page 1837
Error conditions
Defines which error conditions are relevant for the search.
Remote command:
SEARch:TRIGger:RFFE:ERRor:LENGth on page 1837
SEARch:TRIGger:RFFE:ERRor:PARity on page 1837
SEARch:TRIGger:RFFE:ERRor:SSC on page 1838
RFFE (option R&S
RTP-K40)