Rohde & Schwarz RTP Series - Page 725

Protocol analysis
R&S
®
RTP
725User Manual 1337.9952.02 ─ 12
Prepare length
Sets the prepare length.
LCC Type
Selects the type of LCC command to be triggered on.
"Any LCC Command"
All the available LCC commands
"HIBERN8-SLEEP"
Switches the power-saving state to ultra-low power without configura-
tion loss. This state saves up to 90% power and is used with PWM
burst.
"HIBERN8-STALL"
Switches the power-saving state to ultra-low power without configura-
tion loss. This state saves up to 75% power and is used with HS
burst.
"READ-CAPABILITY"
Recovers data about the Optical Media Converter (OMC) capabilities
"READ-MFG-INFO"
Retrieves manufacturing ID and vendor-specific information
"READ-VEND-INFO"
Retrieves the additional four delimited bytes containing vendor-spe-
cific information
"WRITE-ATTRIBUTE"
Sets the configuration parameters required for lane operation
"PWM-G0/PWM-G1/PWM-G2/PWM-G3/PWM-G4/PWM-G5/PWM-G6/PWM-G7"
Switches the transmission mode to the selected low-power gear
"HS-G1A/HS-G2A/HS-G3A/HS-G4A/HS-G1B/HS-G2B/HS-G3B/HS-G4B"
Switches the transmission mode to the selected high-speed gear
M-PHY and USB SSIC (option R&S RTP-K44 and K64)