Rohde & Schwarz RTP Series - Page 726

Protocol analysis
R&S
®
RTP
726User Manual 1337.9952.02 ─ 12
"Reserved"
Reserved bit command. These bits are reserved for future use.
Remote command:
TRIGger<m>:MPHY:LCCType on page 1879
WORD 1/WORD 2/WORD 3/WORD 4
Sets the specified words to be triggered on. The setup for a word consists of the condi-
tion and one or two word patterns.
"Condition"
Sets the comparison condition to a specific value or a range.
"Data Min/Data"
Specifies the value or sets the start value of a range.
In binary format, use the following characters: 1; 0; or X (do not care).
To enter the pattern in other formats use the bit pattern editor, see
Chapter 13.1.7, "Bit pattern editor", on page 519.
"Data Max"
Sets the maximum value of a range for "Condition" = "In range"/"Out
of range".
Remote command:
For " WORD 1":
TRIGger<m>:MPHY:LWONe:CONDition on page 1879
TRIGger<m>:MPHY:LWONe:MIN on page 1880
TRIGger<m>:MPHY:LWONe:MAX on page 1880
For " WORD 2":
TRIGger<m>:MPHY:LWTWo:CONDition on page 1880
TRIGger<m>:MPHY:LWTWo:MIN on page 1881
TRIGger<m>:MPHY:LWTWo:MAX on page 1881
For " WORD 3":
TRIGger<m>:MPHY:LWTHree:CONDition on page 1881
TRIGger<m>:MPHY:LWTHree:MIN on page 1882
TRIGger<m>:MPHY:LWTHree:MAX on page 1882
For " WORD 4":
TRIGger<m>:MPHY:LWFour:CONDition on page 1882
TRIGger<m>:MPHY:LWFour:MIN on page 1883
TRIGger<m>:MPHY:LWFour:MAX on page 1883
TC
Sets the specified Traffic Class (TC) to be triggered on.
TC is used for classifying the traffic flow based on protocol and port number, e.g. TC0
and TC1 are two priority classes with guaranteed link reliability defined and used in L2.
"Data"
Defines the bit pattern of the TC pattern.
In binary format, use the following characters: 1; 0; or X (do not care).
To enter the pattern in other formats use the bit pattern editor, see
Chapter 13.1.7, "Bit pattern editor", on page 519.
Remote command:
TRIGger<m>:MPHY:TC on page 1883
M-PHY and USB SSIC (option R&S
RTP-K44 and K64)