Protocol analysis
R&S
®
RTP
731User Manual 1337.9952.02 ─ 12
4. Tap "Serial bus" and select the serial bus that is set to M-PHY, e.g.:
The "Protocol" selection is then automatically set to "M-PHY".
5. Select the "Type" to use in the M-PHY protocol analysis.
6. To refine the trigger settings, configure additional settings, which are available for
some trigger types.
For details, see Chapter 13.14.3.1, "M-PHY trigger settings", on page 720.
13.14.3.3 SSIC trigger settings
The setting is available for SSIC option R&S RTP-K64.
Error types: Item name, Enable
The table lists the error types you can trigger on. Select the required errors in the
"Enable" column.
Remote command:
TRIGger<m>:MPHY:SSIC:ERENable on page 1921
TRIGger<m>:MPHY:SSIC:ERRor<n>:ENABle on page 1921
M-PHY and USB SSIC (option R&S
RTP-K44 and K64)
To Next Page
Loading...
