Rohde & Schwarz RTP Series - Page 855

Protocol analysis
R&S
®
RTP
855User Manual 1337.9952.02 ─ 12
To specify these parameters, select a field from this list and open "Set details". You can
define the data and/or index operators and values, or the bit state.
The trigger instant is the last criterion that is fulfilled.
Remote command:
TRIGger<m>:USBPd:FRENable on page 2086
TRIGger<m>:USBPd:FRAMe<n>:ENABle on page 2086
Field name / Condition Summary / Enable
This table lists the field numbers and names in the selected frame together with a sum-
mary of the user settings of checking conditions for each field and a checkbox to
enable the checking.
Select a field in the table to specify the checking conditions for this field in the "Data",
"BitState" and/or "Index" dialog (whichever applies). The condition is only applied, and
the "Condition Summary" is only shown in the table, if "Enable" is checked.
For an overview of frames and fields, see "Frame packet types" on page 849.
Remote command:
TRIGger<m>:USBPd:FIENable on page 2086
TRIGger<m>:USBPd:FRAMe<n>:FLD<o>:ENABle on page 2086
Error > Item name /Enable
The table lists the error types you can trigger on: "CRC Error", "Length Error", "4b5b
Error". Enable any error that you want to trigger on in the "OR" column.
Remote command:
TRIGger<m>:USBPd:ERENable on page 2085
TRIGger<m>:USBPd:ERRor<n>:ENABle on page 2085
Data
Sets the data to be triggered on. The trigger data setup consists of a comparison con-
dition and one or two data patterns.
"Condition"
Sets the comparison condition to a specific value or a range.
"Min"
Specifies the value or sets the start value of a range.
"Max"
Sets the maximum value of a range for "Condition" = "In range"/"Out
of range".
Remote command:
TRIGger<m>:USBPd:DOPerator on page 2088
TRIGger<m>:USBPd:FRAMe<n>:FLD<o>:DOPerator on page 2088
TRIGger<m>:USBPd:DMAX on page 2087
TRIGger<m>:USBPd:FRAMe<n>:FLD<o>:DMAX on page 2087
TRIGger<m>:USBPd:DMIN on page 2088
TRIGger<m>:USBPd:FRAMe<n>:FLD<o>:DMIN on page 2088
Data BitState
Defines the bit state to be checked for the selected field. Permitted bit states are "1",
"0" or "X" (do not care).
USBPD (option R&S
RTP-K63)