Rohde & Schwarz RTP Series - Page 877

Protocol analysis
R&S
®
RTP
877User Manual 1337.9952.02 ─ 12
Link
Selects the link width, the number of lanes that are used for the transmission of the
data.
Remote command:
BUS<m>:PCIE:LNKW on page 2124
Descrambling
Enables descrambling of the data.
Remote command:
BUS<m>:PCIE:DSCRambling on page 2123
Lane 0/1/2/3
Select the signal sources for the logical lanes.
Usually, the source is one of the analog channels. Reference and math waveforms are
available as source if the trigger source is one of the analog channels but not the serial
bus.
Remote command:
BUS<m>:PCIE:LZER:SOURce on page 2124
BUS<m>:PCIE:LONE:SOURce on page 2125
BUS<m>:PCIE:LTWO:SOURce on page 2125
BUS<m>:PCIE:LTHRee:SOURce on page 2125
Thresholds
Sets the threshold value for digitization of signals for each line.
PCIe (option R&S RTP-K72/K73)