Rohde & Schwarz RTP Series - Page 884

Protocol analysis
R&S
®
RTP
884User Manual 1337.9952.02 ─ 12
Make sure that:
●
In the [Protocol] > "Setup" tab:
– The correct "Protocol" is selected.
– The data sources of the serial bus are channel signals.
●
In the "Trigger" > "Setup" tab:
– The "Trigger on" = "Single event"
– The trigger "Source" = "Serial bus".
– The correct "Serial bus" is selected.
Trigger level
Defines the trigger level for PCIe 3.
Remote command:
TRIGger<m>:PCIE:TRGLevel on page 2131
Trigger type PCI express
Selects the trigger type for the PCI express analysis.
"TLP (Transac-
tion layer)"
Sets the trigger on a defined type of the transaction layer packet.
"DLLP (Data
link layer)"
Sets the trigger on a defined type of the data link layer packet.
"Ordered Sets"
Sets the trigger on a defined ordered set.
"Error Condi-
tion"
Sets the trigger on a selection of error conditions.
Remote command:
TRIGger<m>:PCIE:TYPE on page 2140
TLP (Transaction layer)
Specifies the trigger conditions for the transaction layer type trigger.
PCIe (option R&S
RTP-K72/K73)