Rohde & Schwarz RTP Series - Page 912

Protocol analysis
R&S
®
RTP
912User Manual 1337.9952.02 ─ 12
DDR search
You can select one or more frames to be searched for. Available are "Read", "Write, ",
"Read NC" and "Write NC ". You can also define the data and/or index operators and
values for the field, see Set details.
Remote command:
SEARch:TRIGger:DDR:FRENable on page 2177
SEARch:TRIGger:DDR:FRAMe<m>:ENABle on page 2178
Error type
You can search for "Frame Incomplete" and "Length error".
Remote command:
SEARch:TRIGger:DDR:ERRor<m>:ENABle on page 2176
SEARch:TRIGger:DDR:ERENable on page 2176
Set details
In this dialog, you can define the individual search parameters for the fields of the
selected frame. Select the frame type first, and then open the "Details" dialog.
Remote command:
SEARch:TRIGger:DDR:FIENable on page 2177
Value ← Set details
Sets the data value of the field to be searched for. The search data setup consists of a
comparison condition and one or two data patterns.
"Condition"
Sets the comparison condition to a specific value or a range.
DDR (option R&S RTP-K91/K93 )