Instrument setup
R&S
®
RTP
102User Manual 1337.9952.02 ─ 12
Show tabs always
If selected, the tab titles of all diagrams are displayed: "Diagram1", "Diagram2" ...
If cleared, the tab titles are not shown except for titles in a tabbed diagram. In tabbed
diagrams, the tab titles are required to change the tabs.
Remote command:
DISPlay:DIAGram:TITLe on page 1167
Show signal bar
If enabled, the signal bar is displayed on the right of the diagram area.
The signal bar contains signal icons that display either real-time views of minimized
waveforms, or the main settings of displayed waveforms. On the top of the bar, the
timebase label and trigger label provide general information for all displayed channels.
Remote command:
DISPlay:SIGBar[:STATe] on page 1167
Show date / time
If enabled, the date and time are shown near to the Rohde & Schwarz logo at the
upper right corner of the screen.
Evaluation gate in zoom
If enabled, the available histogram areas, masks, and measurement gates are shown
in the zoom diagrams. If the evaluation gate is within the zoom area, the display helps
to move or modify the evaluation gates in the zoom window.
Appearance settings
To Next Page
Loading...
