Rohde & Schwarz RTP044 - Page 1353

Remote control commands
R&S
®
RTP
1353User Manual 1337.9952.02 ─ 12
Parameters:
<UseSource2> ON | OFF
*RST: OFF
Usage: Asynchronous command
Firmware/software: FW 3.60
CURSor<m>:TRACking[:STATe] <TrackCurve>
If set to ON, the horizontal cursor lines follow the waveform.
Suffix:
<m>
.
1..4
Selects the cursor set.
Parameters:
<TrackCurve> ON | OFF
*RST: OFF
Usage: Asynchronous command
CURSor<m>:X1Position <XPosition1>
Defines the position of the left vertical cursor line.
Suffix:
<m>
.
1..4
Selects the cursor set.
Parameters:
<XPosition1> Range: 0 to 500
Increment: 0.1
*RST: 0
Default unit: s
Usage: Asynchronous command
CURSor<m>:X2Position <XPosition2>
Defines the position of the right vertical cursor line.
Suffix:
<m>
.
1..4
Selects the cursor set.
Parameters:
<XPosition2> Range: 0 to 500
Increment: 0.1
*RST: 0
Default unit: s
Usage: Asynchronous command
Cursor measurements