Remote control commands
R&S
®
RTP
1364User Manual 1337.9952.02 ─ 12
MEASurement<m>:MAIN <MeasType>
Defines the measurement that is used as a source for math calculations and result
analysis. This measurement is mandatory in the measurement group. Further mea-
surements are added to the measurement group with MEASurement<m>:
ADDitional.
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page 1359.
Parameters:
<MeasType> Amplitude/time measurements
HIGH | LOW | AMPLitude | MAXimum | MINimum | PDELta |
MEAN | RMS | STDDev | POVershoot | NOVershoot | AREA |
RTIMe | FTIMe | PPULse | NPULse | PERiod | FREQuency |
PDCYcle | NDCYcle | CYCarea | CYCMean | CYCRms |
CYCStddev | PULCnt | DELay | PHASe | BWIDth | PSWitching |
NSWitching | PULSetrain | EDGecount | SHT | SHR | DTOTrig-
ger | PROBemeter | SLERising | SLEFalling | ATAR
See Chapter 22.12.3, "Amplitude/time measurements",
on page 1370.
*RST value for amplitude/time measurements: AMPLitude.
Jitter measurements
CCJitter | NCJitter | CCWidth | CCDutycycle | TIE | UINTerval |
DRATe | SKWDelay | SKWPhase
Only available isf option R&S RTP-K12 is installed. See Chap-
ter 22.22.1, "Jitter measurements (option R&S RTP-K12)",
on page 2256.
Eye diagram measurements
ERPercent | ERDB | EHEight | EWIDth | ETOP | EBASe | QFAC-
tor | RMSNoise | SNRatio | DCDistortion | ERTime | EFTime |
EBRate | EAMPlitude | PPJitter | STDJitter | RMSJitter
See Chapter 22.12.5, "Eye diagram measurements",
on page 1388
*RST value for eye/jitter measurements: ERPercent.
Spectrum measurements
CPOWer | OBWidth | SBWidth | THD | THDPCT | THDA | THDU
| THDR | PLISt | HAR | THDF | SPAR
See Chapter 22.12.6, "Spectrum", on page 1391.
*RST value for spectrum measurements: CPOWer.
Histogram measurements
WCOunt | WSAMples | HSAMples | HPEak | PEAK | UPEak-
value | LPEakvalue | HMAXimum | HMINimum | MEDian | MAX-
Min | HMEan | HSTDdev | M1STddev | M2STddev | M3STddev |
MKPositive | MKNegative
See Chapter 22.12.7.2, "Histogram measurement",
on page 1404.
*RST value for histogram measurements: WCOunt.
Automatic measurements
To Next Page
Loading...
