Rohde & Schwarz RTP044 - Page 1424

Remote control commands
R&S
®
RTP
1424User Manual 1337.9952.02 ─ 12
Usage: Asynchronous command
MEASurement<m>:GATE:MODE <Mode>
Defines whether the gate settings are configured using absolute or relative values.
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page 1359.
Parameters:
<Mode> ABS | REL
*RST: ABS
Usage: Asynchronous command
MEASurement<m>:GATE:ABSolute:STARt
<Start>
MEASurement<m>:GATE:ABSolute:STOP <Stop>
Define the absolute start and end values for the gate.
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page 1359.
Parameters:
<Stop> Range: -100E+24 to 100E+24
Increment: 0.01
*RST: 0.01
Usage: Asynchronous command
MEASurement<m>:GATE:RELative:STARt <RelativeStart>
MEASurement<m>:GATE:RELative:STOP <RelativeStop>
Define the relative start and end values for the gate, respectively.
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page 1359.
Parameters:
<RelativeStop> Range: 0 to 100
Increment: 0.1
*RST: 100
Default unit: %
Usage: Asynchronous command
Automatic measurements