Remote control commands
R&S
®
RTP
1450User Manual 1337.9952.02 ─ 12
TIMebase:RACTime?
Queries the required acquisition time. If FFT gating is used and the resolution BW is
set to constant, record length can be extended to acquire the required number of sam-
ples. In this case, the required acquisition time differs from the adjusted acquisition
time (TIMebase:RANGe).
Return values:
<RqrdAcqTime> Required acquisition time for FFT
Range: 125E-12 to 100E+3
*RST: 0.5
Default unit: s
Usage: Query only
Asynchronous command
CALCulate:MATH<m>:FFT:GATE:ABSolute:STARt
<Start>
Defines the starting value for the gate.
Suffix:
<m>
.
1..8
math waveform
Parameters:
<Start> Range: -100E+24 to 100E+24
Increment: 0.01
*RST: 0
Usage: Asynchronous command
CALCulate:MATH<m>:FFT:GATE:ABSolute:STOP <Stop>
Defines the end value for the gate.
Suffix:
<m>
.
1..8
math waveform
Parameters:
<Stop> Range: -100E+24 to 100E+24
Increment: 0.01
*RST: 0.01
Usage: Asynchronous command
CALCulate:MATH<m>:FFT:GATE:MODE <Mode>
Defines whether the gate settings are configured using absolute or relative values.
Suffix:
<m>
.
1..8
math waveform
Spectrum analysis
To Next Page
Loading...
