Remote control commands
R&S
®
RTP
1458User Manual 1337.9952.02 ─ 12
Parameters:
<State> ON | OFF
*RST: OFF
Usage: Asynchronous command
CALCulate:MATH<m>:FFT:SPECtrogram:TIMeline<n>:POSition <Position>
Defines the position of one of the two possible time lines in a spectrogram. The time
line must be enabled first, using the CALCulate:MATH<m>:FFT:SPECtrogram:
TIMeline<n>:STATe command.
Suffix:
<m>
.
1..8
<n> 1..2
Parameters:
<Position> The position of the time line is defined by the index of the data
acquisition in the history. How many acquisitions are available
depends on the history settings.
Range: 0 to 4294967295
Increment: 1
*RST: 0
Usage: Asynchronous command
CALCulate:MATH<m>:FFT:SPECtrogram:TIMeline<n>:STATe <State>
Enables one of two possible time lines in a spectrogram diagram. A time line marks a
single waveform in the spectrogram, that is: the power vs frequency results for the data
acquired at a specific time. After enabling a time line, the results for that time are dis-
played in the spectrum diagram.
The position of the time line is defined using the CALCulate:MATH<m>:FFT:
SPECtrogram:TIMeline<n>:POSition command.
Suffix:
<m>
.
1..8
<n> 1..2
Parameters:
<State> ON | OFF
*RST: OFF
Usage: Asynchronous command
Spectrum analysis
To Next Page
Loading...
