Rohde & Schwarz RTP044 - Trigger Settings for All Serial Protocols

Remote control commands
R&S
®
RTP
1552User Manual 1337.9952.02 ─ 12
22.17.2 Trigger Settings for all serial protocols
The following commands are available for all serial protocols that have a protocol trig-
ger.
TRIGger<m>:SOURce[:SELect].....................................................................................1552
TRIGger<m>:SOURce:SBSelect................................................................................... 1553
BUS<m>:TYPE............................................................................................................1553
TRIGger<m>:SOURce[:SELect] <SourceDetailed>
Selects the source of the trigger signal.
Suffix:
<m>
.
1..3
1 = A-trigger, 2 = B-trigger, 3 = R-trigger
Available values depend on the selected trigger source. For
input channels CHAN1...4, a trigger sequence can be config-
ured.
For all other trigger sources, only suffix 1 is allowed.
Parameters:
<SourceDetailed> CHAN1 | CHANnel1 | CHAN2 | CHANnel2 | CHAN3 |
CHANnel3 | CHAN4 | CHANnel4 | EXTernanalog | SBUS | D0 |
D1 | D2 | D3 | D4 | D5 | D6 | D7 | D8 | D9 | D10 | D11 | D12 |
D13 | D14 | D15 | LOGIC | MSOB1 | MSOB2 | MSOB3 |
MSOB4 | Z1V1 | Z1V2 | Z1V3 | Z1V4 | Z1I1 | Z1I2 | Z1I3 | Z1I4 |
Z2V1 | Z2V2 | Z2V3 | Z2V4 | Z2I1 | Z2I2 | Z2I3 | Z2I4 | DIFF1 |
DIFF2 | COMMON1 | COMMON2 | LINE
CHAN1 = CHANnel1, CHAN2 = CHANnel2, CHAN3 = CHAN-
nel3, CHAN4 = CHANnel4
Input channels
EXTernanalog
External analog signal connected to the External Trigger Input.
For this source, only the analog edge trigger is available.
LINE
The instrument generates the trigger from the AC power input
and synchronizes the signal to the AC power frequency.
SBUS
Serial bus
D0...D15
Digital channels (option R&S RTP-B1)
See also: Chapter 22.18.4, "Trigger settings for digital signals
and parallel buses", on page 2208
LOGIc
Logic combination of digital channels, used as trigger source
(option R&S RTP-B1)
MSOB1 | MSOB2 | MSOB3 | MSOB4
Parallel bus (option R&S RTP-B1)
Protocols