Rohde & Schwarz RTP044 - Page 1575

Remote control commands
R&S
®
RTP
1575User Manual 1337.9952.02 ─ 12
Usage: Asynchronous command
SEARch:TRIGger:I2C:ACCess <SearchName>,<RWBitAddress>
SEARch:TRIGger:I2C:ACCess? <SearchName>
Sets the transfer direction of the data.
Parameters:
<RWBitAddress> READ | WRITe | EITHer
*RST: EITHer
Parameters for setting and query:
<SearchName>
Usage: Asynchronous command
SEARch:TRIGger:I2C:ADDO<m>:ENABle <SearchName>,<UseAddress>
SEARch:TRIGger:I2C:ADDO<m>:ENABle? <SearchName>
Includes the indicated ADOR address in the "address OR" search condition.
Suffix:
<m>
.
1..4
Index of the address in an "address OR" condition (OR slot)
Parameters:
<UseAddress> ON | OFF
*RST: OFF
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:I2C:ADDO<m>:ADRType <SearchName>,<AddressType>
SEARch:TRIGger:I2C:ADDO<m>:ADRType? <SearchName>
Sets the address type for the indicated ADOR address in the "address OR" search
condition.
Suffix:
<m>
.
1..4
Index of the address in an "address OR" condition (OR slot)
Parameters:
<AddressType> BIT7 | BIT7_RW | BIT10
BIT7 | BIT10
Enter only address bits in the address pattern.
BIT7_RW
Enter seven address bits and also the R/W bit in the address
pattern.
*RST: BIT7
Protocols