Rohde & Schwarz RTP044 - Page 1686

Remote control commands
R&S
®
RTP
1686User Manual 1337.9952.02 ─ 12
Parameters:
<SourceData> C1W1 | C2W1 | C3W1 | C4W1 | M1 | M2 | M3 | M4 | M5 | M6 |
M7 | M8 | R1 | R2 | R3 | R4
*RST: C1W1
BUS<m>:MILStd:MAXResponse:BITS <MaxResponseTime>
Sets the value for the maximum response time.
See also: BUS<m>:MILStd:MAXResponse:SELect.
Suffix:
<m>
.
1..4
Parameters:
<MaxResponseTime> Range: 2E-6 to 262E-6
Increment: 100E-9
*RST: 14E-6
Default unit: s
BUS<m>:MILStd:MAXResponse:SELect <MaxRespSel>
Enables the detection of the maximum response time between the last bit of a word
and the following status word sync during decoding.
To specify the maximum response time, use BUS<m>:MILStd:MAXResponse:BITS
on page 1686.
Suffix:
<m>
.
1..4
Parameters:
<MaxRespSelect> ON | OFF
*RST: ON
BUS<m>:MILStd:MINGap:SELect <MinGapSelect>
Enables the detection of the minimum idle time between the last bit of a message and
the following command word sync during decoding.
To specify the minimum gap, use BUS<m>:MILStd:MINGap:BITS.
Suffix:
<m>
.
1..4
Parameters:
<MinGapSelect> ON | OFF
*RST: ON
BUS<m>:MILStd:MINGap:BITS <MinGapTime>
Sets a value for the minimum gap.
Protocols