Rohde & Schwarz RTP044 - Page 1743

Remote control commands
R&S
®
RTP
1743User Manual 1337.9952.02 ─ 12
SEARch:TRIGger:ETHernet:FRAMe:SMAX <SearchName>,<SrcAddrPattMax>
SEARch:TRIGger:ETHernet:FRAMe:SMAX? <SearchName>
Sets the end value of a source address range, if SEARch:TRIGger:ETHernet:
FRAMe:SCONdition is set to INRange or OORange.
Parameters:
<SrcAddrPattMax> Numeric or string pattern, see Chapter 22.4.6, "Bit pattern
parameter", on page 1148. The string parameter accepts the bit
value X (don't care).
Parameters for setting and query:
<SearchName> String parameter
SEARch:TRIGger:ETHernet:FRAMe:TCONdition <SearchName>,<TypeOperator>
SEARch:TRIGger:ETHernet:FRAMe:TCONdition? <SearchName>
Defines the operator to search for a specific frame length or type.
Parameters:
<TypeOperator> EQUal | NEQual | LTHan | LETHan | GTHan | GETHan |
INRange | OORange
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less than or equal, Greater Than,
Greater than or equal. These conditions require a pattern to be
set with SEARch:TRIGger:ETHernet:FRAMe:TMIN.
INRange | OORange
In range, Out of range. Set the minimum and maximum value of
the range with SEARch:TRIGger:ETHernet:FRAMe:TMIN
and SEARch:TRIGger:ETHernet:FRAMe:TMAX.
*RST: EQUal
Parameters for setting and query:
<SearchName> String parameter
SEARch:TRIGger:ETHernet:FRAMe:TMIN <SearchName>,<TypePatternMin>
SEARch:TRIGger:ETHernet:FRAMe:TMIN? <SearchName>
Defines a frame length/type, or sets the start value for a range of frame lengths/types.
Parameters:
<TypePatternMin> Numeric or string pattern, see Chapter 22.4.6, "Bit pattern
parameter", on page 1148. The string parameter accepts the bit
value X (don't care).
Parameters for setting and query:
<SearchName> String parameter
Protocols