Rohde & Schwarz RTP044 - Page 1846

Remote control commands
R&S
®
RTP
1846User Manual 1337.9952.02 ─ 12
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<ThresLPDP0High> Range: -1.5 to 1.5
Increment: 0.01
*RST: 0.88
Default unit: V
BUS<m>:DPHY:DNZero:LPOWer:THLower <ThresLPDN0Low>
BUS<m>:DPHY:DPZero:LPOWer:THLower <ThresLPDP0Low>
Sets the lower threshold value for the respective lane used for the low power mode.
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<ThresLPDP0Low> Range: -1.5 to 1.5
Increment: 0.01
*RST: 0.55
Default unit: V
BUS<m>:DPHY:DPZero:SOURce <DataSource>
Selects the source of the DP0 data line.
Suffix:
<m>
.
1..4
Parameters:
<DataSource> C1W1 | C2W1 | C3W1 | C4W1 | M1 | M2 | M3 | M4 | M5 | M6 |
M7 | M8 | R1 | R2 | R3 | R4
*RST: C1W1
BUS<m>:DPHY:DNZero:SOURce <DataSource>
BUS<m>:DPHY:DPONe:SOURce <DataSource>
BUS<m>:DPHY:DPTWo:SOURce <DataSource>
BUS<m>:DPHY:DPTHree:SOURce <DataSource>
Selects the source of the corresponding data line.
Suffix:
<m>
.
1..4
Selects the serial bus.
Protocols