Rohde & Schwarz RTP044 - Page 1847

Remote control commands
R&S
®
RTP
1847User Manual 1337.9952.02 ─ 12
Parameters:
<DataSource> NONE | C1W1 | C2W1 | C3W1 | C4W1 | M1 | M2 | M3 | M4 |
M5 | M6 | M7 | M8 | R1 | R2 | R3 | R4
*RST: DNZero: NONE, DPONe: C2W1, DPTWo: C3W1,
DPTHree: C4W1
BUS<m>:DPHY:DNZero:PROBe <ProbeDN0>
BUS<m>:DPHY:DPZero:PROBe <ProbeDP0>
BUS<m>:DPHY:DPONe:PROBe <ProbeDP1>
BUS<m>:DPHY:DPTWo:PROBe <ProbeDP2>
BUS<m>:DPHY:DPTHree:PROBe <ProbeDP3>
Selects the type of probe used for the corresponding data lane.
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<ProbeDP3> DIFFerential | SINGle
*RST: SINGle
BUS<m>:DPHY:CP:HSPeed:HYSTeresis <HysteresisHSCP>
BUS<m>:DPHY:DPZero:HSPeed:HYSTeresis <HysteresisHSDP0>
BUS<m>:DPHY:DPONe:HSPeed:HYSTeresis <HysteresisHSDP1>
BUS<m>:DPHY:DPTWo:HSPeed:HYSTeresis <HysteresisHSDP2>
BUS<m>:DPHY:DPTHree:HSPeed:HYSTeresis <HysteresisHSDP3>
Sets a value for the hysteresis of the respective lane.
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<HysteresisHSDP3> Range: 0 to 0.5
Increment: 0.01
*RST: 0.2
Default unit: V
BUS<m>:DPHY:CP:HSPeed:THReshold <ThresholdHSCP>
BUS<m>:DPHY:DPZero:HSPeed:THReshold <ThresholdHSDP0>
BUS<m>:DPHY:DPONe:HSPeed:THReshold <ThresholdHSDP1>
BUS<m>:DPHY:DPTWo:HSPeed:THReshold <ThresholdHSDP2>
BUS<m>:DPHY:DPTHree:HSPeed:THReshold <ThresholdHSDP3>
Sets the threshold value for the digitization of the respective high speed data line.
Suffix:
<m>
.
1..4
Selects the serial bus.
Protocols