Rohde & Schwarz RTP044 - Page 1980

Remote control commands
R&S
®
RTP
1980User Manual 1337.9952.02 ─ 12
Parameters:
<DXSymbol> Range: 0 to 31
Increment: 1
*RST: 0
TRIGger<m>:EBTB:DY <DYSymbol>
Sets the y value of the data character Dx.y to be triggered on, if TRIGger<m>:EBTB:
SYMType is set to Dxy.
Parameters:
<DYSymbol> Range: 0 to 7
Increment: 1
*RST: 0
TRIGger<m>:EBTB:EBPA <EBPattern>
Sets the 8-bit pattern to be triggered on, if TRIGger<m>:EBTB:STYPe is set to EB.
Parameters:
<EBPattern>
TRIGger<m>:EBTB:GLITcherror <GlitchError>
Defines, if a trigger on a glitch error is activated or not.
Parameters:
<GlitchError> ON | OFF
*RST: OFF
TRIGger<m>:EBTB:SSTYpe <SymbolType>
Selects the symbol type to be triggered on. You can select a single symbol or an
expression (defined series of symbols).
Parameters:
<SymbolType> SYMBol | EXPRession
*RST: SYMBol
TRIGger<m>:EBTB:SYME <Expression>
Selects the format of the symbol to be triggered on, if TRIGger<m>:EBTB:SSTYpe is
set to EXPRession.
Parameters:
<Expression>
Protocols