Rohde & Schwarz RTP044 - Page 2019

Remote control commands
R&S
®
RTP
2019User Manual 1337.9952.02 ─ 12
BUS<m>:USB:PACKet<n>:PID?....................................................................................2019
BUS<m>:USB:PACKet<n>:ADDRess?...........................................................................2020
BUS<m>:USB:PACKet<n>:CRC?.................................................................................. 2020
BUS<m>:USB:PACKet<n>:DATA?.................................................................................2021
BUS<m>:USB:PACKet<n>:ENDPoint?...........................................................................2021
BUS<m>:USB:PACKet<n>:ET?.....................................................................................2021
BUS<m>:USB:PACKet<n>:FRAMe?.............................................................................. 2022
BUS<m>:USB:PACKet<n>:PORT?................................................................................ 2022
BUS<m>:USB:PACKet<n>:SC?.....................................................................................2022
BUS<m>:USB:PACKet<n>:SEU?.................................................................................. 2023
BUS<m>:USB:PACKet<n>:STARt?................................................................................2023
BUS<m>:USB:PACKet<n>:STATus?..............................................................................2023
BUS<m>:USB:PACKet<n>:STOP?................................................................................ 2024
BUS<m>:USB:PCOunt?............................................................................................... 2024
BUS<m>:USB:PACKet<n>:PID?
Returns the packet PID for the selected serial bus and packet number.
Suffix:
<m>
.
1..4
<n> *
Return values:
<PID> RES | OUT | ACK | DATA0 | DATa0 | PING | SOF | NYET |
DATA2 | DATa2 | SPLIT | SPLit | IN | NAK | DATA1 | DATa1 |
PRE | SETUP | SETup | STALL | STALl | MDATA | MDATa | UNK
RES
RES = Reserved
OUT
OUT Token PID
IN
IN Token PID
SOF
Start Of Frame PID
SETUP = SETup
SETUP PID
DATA0 = DATa0
DATA0 PID, even PID
DATA1 = DATa1
DATA1 PID, odd PID
DATA2 = DATa2
DATA2 PID (only valid in USB high speed and USB HSIC proto-
cols)
MDATA = MDATa
MDATA PID (only valid in USB high speed and USB HSIC proto-
cols)
Protocols