Rohde & Schwarz RTP044 - Page 2047

Remote control commands
R&S
®
RTP
2047User Manual 1337.9952.02 ─ 12
Parameters:
<PoleOneFreq> Range: 1 to 40E+9
Increment: 1
*RST: 0
Default unit: Hz
BUS<m>:CTLE:P2FReq <PoleTwoFreq>
Sets the pole 2 frequency for the transfer function of the CTLE algorithm.
Suffix:
<m>
.
1..4
Parameters:
<PoleTwoFreq> Range: 1 to 40E+9
Increment: 1
*RST: 0
Default unit: Hz
BUS<m>:CTLE:Z1FReq <ZroOneFreq>
Sets the zero frequency for the transfer function of the CTLE algorithm.
Suffix:
<m>
.
1..4
Parameters:
<ZroOneFreq> Range: 1 to 40E+9
Increment: 1
*RST: 0
Default unit: Hz
BUS<m>:USBThree:BITR <HighSpdBitrate>
Sets the bit rate.
Suffix:
<m>
.
1..4
Parameters:
<HighSpdBitrate> Range: 1000 to 3E+9
Increment: 1000
*RST: 3E+9
Default unit: bps
BUS<m>:USBThree:DFE:COEFficient <DFEcoeff>
Sets the value of the coefficient for the DFE .
Suffix:
<m>
.
1..4
Protocols