Remote control commands
R&S
®
RTP
2074User Manual 1337.9952.02 ─ 12
<n> *
Parameters:
<DataOperator> EQUal | NEQual | LTHan | LETHan | GTHan | GETHan |
INRange | OORange
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less than or equal, Greater than,
Greater than or equal. These conditions require one endpoint
value to be set using SEARch:TRIGger:USBThree:
FRAMe<m>:FLD<n>:IMIN.
INRange | OORange
In range, out of range. These conditions require a range of end-
point values to be set using SEARch:TRIGger:USBThree:
FRAMe<m>:FLD<n>:IMIN and SEARch:TRIGger:USBThree:
FRAMe<m>:FLD<n>:IMAX on page 2076.
*RST:
EQUal
Parameters for setting and query:
<SearchName> String with the name of the search.
SEARch:TRIGger:USBThree:DMIN <SearchName>,<Frame>, <Field>, <Data>
SEARch:TRIGger:USBThree:FRAMe<m>:FLD<n>:DMIN
<SearchName>,<DataMin>
SEARch:TRIGger:USBThree:FRAMe<m>:FLD<n>:DMIN? <SearchName>
Specifies the data pattern to be searched, or sets the start value of a data pattern
range to be searched.
Suffix:
<m>
.
*
Specifies the field number within the frame.
<n> *
Parameters:
<DataMin> Specifies the name of the generic trigger setting frame, see
SEARch:RESult:USBThree:FRAMe<m>:TYPE?
on page 2077.
Parameters for setting and query:
<SearchName> String with the name of the search.
SEARch:TRIGger:USBThree:DMAX <SearchName>,<Frame>, <Field>, <Data>
SEARch:TRIGger:USBThree:FRAMe<m>:FLD<n>:DMAX
<SearchName>,<DataMax>
SEARch:TRIGger:USBThree:FRAMe<m>:FLD<n>:DMAX? <SearchName>
Sets the end value of a data pattern range if SEARch:TRIGger:USBThree:
FRAMe<m>:FLD<n>:DOPerator is set to INRange or OORange.
Protocols
To Next Page
Loading...
